Aston Martin diagnostic trouble code
P0614: ECM / TCM IncompatibleCAN Level
Use this reference to understand the recorded condition, confirm the available V8 Vantage or DB9 manual coverage, and follow the documented diagnostic checks before replacing parts.
- Code family
- Powertrain
- Vehicle system
- Transmission
- Manual coverage
- DB9
- Warning-lamp status
- DB9: MIL
What Aston Martin code P0614 means
ECM / TCM IncompatibleCAN Level
DB9 preliminary diagnostic manual · section 2-146
Manufacturer fault-analysis procedure
Manual fault definition
P0614 - CAN ID does not match that stored in
TCM.
TCM.
Cautions and notes
NOTE: This fault is most likely to occur if a control module has been replaced or swapped between vehicles.
Test sequence and decision path
1. Connect the WDS and confirm that P0614 is
logged. Clear the P0614 code
2. Run a KOER test. Recheck the logged fault codes
3. If P0614 is logged again, check if the
mechatronic unit has been replaced. If so the
software level may be different to that logged for
the vehicle.
4. Consult Aston Martin Technical Support.
Open the corresponding manual page for wiring diagrams and figures
logged. Clear the P0614 code
2. Run a KOER test. Recheck the logged fault codes
3. If P0614 is logged again, check if the
mechatronic unit has been replaced. If so the
software level may be different to that logged for
the vehicle.
4. Consult Aston Martin Technical Support.